bodner062

Pictures of the finished skirt have to wait. I want to hem my skirt with “steam a seam” tape but forgot to buy it and as most of my fabrics and notions are in storage, I had none available at all. So I spent my weekend sewing two t-shirts. The pattern is the Ann T-top from StyleArc: I’ve made this pattern several times now and it’s a great basic. After the initial one last year (never blogged about as far as I remember) I removed the gathers in the front by folding up at waist level. Until recently I used an old Ottobre pattern from 2007 as my base for t-shirts, which is still a great pattern. But, as you can guess, it’s in storage (by accident though). The neckline and hems of both t-shirts were finished with a coverstitch. I’ve had a love/hate relationship with my Janome coverstitch for quite a long time, but have become used to it and now it’s taken out and used regularly. For a long time I did not use it properly either and on the inside you could see the edge of the hem st...

Just wanted to show you where I got with this skirt. All that’s left to do is the inside waistband, lining and hemming. The fabric is a kind of faux suede you see a lot here at the moment in all kind of colors. My fabric is a greyish brown, I had expected it to be more grey than it actually is. The downside of buying online. The wrong side of it feels uncomfortable and sticks to your skin. So anti-static lining is necessary. I might will re-do the zipper as I’m not satisfied with it.     

It was good to step back from the draft for a day or so. This is the basic draft in my skirt block. Because there is more width to be covered than in the original pattern, I realized that I had to change the back if I wanted the center back panel more or less as narrow as the original. I had already made the panels a bit wider, but on the back that was not enough. The dotted line in the back indicate where I started to move out the pattern pieces to create the fullnes in the back. Also a lot of notches to make sure I know which parts belong together. This is an original pattern piece for the back. Below pictures of how I created this on my pattern: I traced the top part to the dotted line (in my block these are the pattern pieces marked 5 and 6). On a separate piece of paper I traced the bottom part, have drawn lines in it and spread the four pieces I now had.   The corner was curved to get a smooth transition. The final pattern piece. For the waistband I closed the d...

This February the Dutch magazine Knip Mode had a skirt in the pattern collection that I was immediately attracted to. There's only one version in the magazine, hemming is not very well done and as so often there is a difference in the line drawing and the actual pattern. In the line drawing the design lines of the front are straight, in the actual pattern these lines are curved, as can be seen in the photo. I prefer the straight lines. I traced the pattern in the size based on my hip measurements. When I checked the circumference I was a little shocked to see so much "negative ease" there was. The skirt is intended to be made from a fabric with stretch, but it would be a lot of stretch for me and my hips are wide enough without stretching fabric over them. So: back to the drawing board, literally (almost, it was the floor, looking forward to a bit more space). My creative space, a mess! Original pattern pieces, my skirt block with lines drawn into it. The worst part is no...